light gray wallpaper This is a topic that many people are looking for. khurak.net is a channel providing useful information about learning, life, digital marketing and online courses …. it will help you have an overview and solid multi-faceted knowledge . Today, khurak.net would like to introduce to you How to hang non-woven wallpaper. Following along are instructions in the video below:
“Today. We are demonstrating how you can install a nonwoven wall. Covering and a vinyl vinyl nonwoven more covering in an easy and professional way. It is easy to work nonwoven wall covering because you can apply the adhesive directly to the wall.
We use roles that are 70 centimeters wide. Read the instructions that come with a wall covering check whether all the roles have the same product reference and badge code. So you can be sure that there will be no color discrepancies unroll them all covering and check whether everything is as it should be the wall must be cleaned before you start. It must be even and smooth decide the point.
Where you re going to start start with the second strip counting from a corner measure. The width of the wall. Covering and subtract. 2 centimeters.
So in this case. It would be 68 centimeters draw a vertical line at this point. We are using a spirit level. But you can also use a plumb line or a laser measure.
The height of the wall. Allow a few extra centimeters and cut the necessary strips to length. Always mark the top edge of the strip. All strip s must be hung in the same direction.
Unless. The instructions state otherwise open the adhesive pail and stir well pour the adhesive into the bucket. Put the ladder and a decent bucket in position brush. The adhesive on to the wall at the top and bottom right up to the edge use the microfiber roller to paste the walls spread the adhesive on both sides a little wider than the strip spread the adhesive evenly and sufficiently thickly roll up the strip with a rear surface on the outside the marking.
You drew on the top of the edge strip is on the outside little bit extra the top and bottom and position the strip against the vertical line in the adhesive press gently with a spatula and remove any bubbles press. The wall covering well onto the wall at the top and bottom. Hold the snap off cutter against the spatula and cut off the surplus paper. Always use a sharp blade preferably use a new piece of the snap off cutter blade for each cut paste the rest of the wall.
And use the brush again for the corner place. The second strip against the first one again allow a little extra wall covering at the top and bottom slide. The strip. Until it is hanging just right and then press weld with a spatula press.
The scene between the two strips with the seam roller cut off a surplus piece in the corner against the floor. And the ceiling. If you re working with washable wallcovering rub each strip completely clean with a sponge using clean water in the meantime. Also clean the ceiling and the skirting boards continue pasting the wall for the third strip and place.
The strip into the adhesive. After three strips check whether the result is good continue until the whole wall is covered and deal with the next corner in the same way as the first one draw a vertical line on the other side of the corner cover this more in the same way you can now finish. The whole room thanks for watching and good luck you ” ..
Thank you for watching all the articles on the topic How to hang non-woven wallpaper. All shares of khurak.net are very good. We hope you are satisfied with the article. For any questions, please leave a comment below. Hopefully you guys support our website even more.